MS309 CAN BUS OBDII/EOBD Car Engine Code Reader

This product does not have a LOGO. If you need a product with a LOGO, please contact customer service to confirm whether it is in stock, thank you!

Brief Description

The MS309 CAN OBDII/EOBD code reader provides DIYers easy and quick access to diagnostic trouble codes and their definitions on all OBDII compliant vehicles sold worldwide since 1996. Though small in size, it is powerful enough to retrieve the same information as large expensive scanners. It is the best solution to diagnose all 1996 and newer OBDII compliant vehicles!

Features

· Works with all 1996 and later OBDII compliant US, European and Asian vehicles

· Display DTC definitions on unit screen

· Easily determines the cause of the “Check Engine Light (MIL)”

· Turns off Check Engine Light (MIL), clears codes and resets monitors

· Retrieves generic (P0, P2, P3 and U0), manufacturer specific (P1, P3 and U1) codes and pending codes

· Views freeze frame data

· Display monitor and I/M readiness status (emissions)

· Retrieves vehicle information (VIN, CIN and CVN)

· Supports CAN (Controller Area Network) and all other current OBD-II protocols

· Language: English, Spanish, French, German, Dutch

· Easy to use and highly reliable

Compatible Protocols

CAN/KWP 2000/ISO 9141-2/J1850 VPW/J1850 PWM.
Supports ISO, VPW and PWM bus systems as well as CANBUS systems.

Support vehicles:

U.S. Models – European – Japanese – Asian – German – Korean.
Suitable for almost all cars after 1996 .
GM ’96 – now (OBD-II)
Ford ’96 – now (OBD-II)
Chrysler ’96 – now (OBD-II)
Toyota ’96 – now (OBD-II)
Honda ’96 – now (OBD-II)
NISSAN ’96 – now (OBD-II)
All other – Asian and European ’96 – 2012(OBD-II).

Using the Scan Tool Procedures:

1) Turn the ignition off.
2) Locate the vehicle’s 16-pin Data Link Connector(DLC).
3) Connect the Scan Tool cable connector to the vehicle ‘s DLC. The cable connector is keyed
and will only fit one way. (If you have problems connecting the cable connector to the DLC, rotate
the connector 180 and try again.
4) Turn the ignition on. But do not start the engine.
5) When the Scan Tool cable connector is properly connect to the vehicle’s DLC, the LCD display
shows instructions for select New Scan.
6) Press the New Scan button. A sequence of message showing the OBD2 protocols will be observed
on the display until the vehicle Protocols.

Note:

If the Scan Tool fails to communicate with the vehicle’s computer, an Unable to establish a link with the vehicle message shows up.
-Verify that the ignition is ON.
-Check if the Scan Tool’s OBD2 connector is securely connected to the vehicle’s DLC.
-Verify that the vehicle is OBD2 compliant.
-Turn the ignition off and wait for about 10 seconds. Turn the ignition back to on and repeat the procedure from the step 6.

Package Included

· 1 x MS309 Car Code Reader

· 1 x Manual